Our Process

How gas fireplaces are installed in Winter Springs

How a direct-vent gas fireplace installation stays sealed

A direct-vent fireplace depends on its glass front staying sealed. One direct-vent manual warns that combustion products can leak past a glass door that is not properly seated and sealed. In one direct-vent manual the vent is concentric, an inner flue inside an outer pipe, giving exhaust and outside air separate paths.

During installation our crew seats the glass as the manual shows, joins each vent section as the maker specifies and checks the seal before the first light. Those steps happen out of sight once the wall is finished, which is why they are written on your Winter Springs record.

Keeping a gas fireplace vent cap away from the meter and air intakes

The gas meter and regulator and any fresh air intake on the house all affect where a vent cap can go. Table 503.8 keeps a direct-vent cap 3 feet from a service regulator vent outlet at pressures up to 2 psi, and 10 feet horizontally or 3 feet above a mechanical air supply inlet.

Those distances often decide which side of the room the fireplace ends up on. Our specialists find the meter, the regulator and any intakes on your Winter Springs home during the free inspection so the location is settled once.

Facing materials around a gas fireplace

Tile, stone and brick veneer can dress up a gas fireplace, but only within the maker's rules. One B-vent manual allows only noncombustible materials over the black face of the unit, attached with adhesive rated for at least 300 degrees F, with sealant at the joint to the wall rated the same.

Before you pick a finish, our specialists check what your model's instructions allow at the face and around it. If a stone mason or tile setter is finishing the wall in your Winter Springs home, we share those limits with them first.

Normal quirks of a newly installed gas fireplace

A few things surprise new owners. One maker's manual explains that condensation on the glass at startup is normal and clears as the unit warms, that flames start blue and turn more yellow as the unit heats, and that ticking or metallic noises come from metal expanding and contracting.

It also says a film on the glass after the first burns is normal and should be cleaned with a non-abrasive gas fireplace glass cleaner. We go over each of these during the walkthrough in your Winter Springs home, so nothing new sounds like a fault.